The 1810 Company products feature the highest degree of technology, quality and design. As a result, we are proud to offer the following warranty.
The 1810 Company warrants its sinks to be free of manufacturing defects in material and workmanship under normal residential usage for 75 years.
All taps installed in a private residence carry a 2-year warranty on all mechanical parts to be free of manufacturing defects in material and workmanship under normal usage. All finishes carry a 2 year warranty.
In the event of a warranty claim, the owner will be required to provide proof of purchase, a sales receipt. This warranty covers all components, which make the product operational. The 1810 Company, at its option, may repair or replace the product or components necessary to restore the product to good working condition. The 1810 Company reserves the right to inspect the installation prior to the actual replacement of the product or component part.
This warranty does not cover misuse or abuse, accidental damages, scuffs or scratches, improper installation, abnormal usage, negligence or damage caused by improper maintenance or cleaning. Normal wear of parts is excluded from the warranty. Damage caused by impurities or acts beyond our control are not covered. Any product or part, which has been repaired or altered in any manner outside of The 1810 Company’s factory, unless previously authorised in writing by The 1810 Company, will void warranty. Any replacement excludes transportation and any labour re-installation costs.
Discolouration and most marks on stainless steel are caused by water-borne deposits clinging to its surface. They are always the result of an outside source rather than coming from the steel itself. Such stains are often seen as a “rainbow-effect” and can be avoided completely by removing wet cleaning aids (cloths, containers etc.) from the sink after use so as to avoid watermarking and rust stains.
One of the best ways to care for the sink is to clean it with a product called ‘ShinySinks’ (available from most major supermarkets) which can be used daily. It is helpful to dry the sink thoroughly after cleaning.
(a) the use of plastic bowls for washing up, as these cause heavy localised scratching.
(b) Leaving salt, vinegar, citric fruit juices, mustard or pickles on the surface for any length of time as they can cause corrosion.
(c) abrasive cleaners such as bleach, scourers or wire woolpads.
Care needs to be taken not to damage the tap finish – cleaning should be gentle with a rinsed soft mild soapy cloth only. If limescale is a problem around the nozzle then gentle use of a small brush with some lemon juice will help alleviate the problem –taking care to rinse away any remaining lemon juice from the tap.
The surface scratches which appear on stainless steel sinks rarely have any appreciable depth and will become less noticeable with age. A stainless steel sink will develop a patina with time and will look better a year after installation than during the first few months of use due to the fact that the scratching will have evened out. All sinks manufactured in stainless steel perform in exactly the same way in this respect be they manufactured by The 1810 Company or a competitor. We recommend the use of ‘ShinySinks’ which when used regularly will assist in maintaining your sink.
We would point out that the use of a plastic washing up bowl will over time cause the development of regular abrasion marks over the sink’s surface. Inox Cream – for use on stainless steel to be used after ‘ShinySinks’. To use the Inox Cream, apply with a damp cloth (like a J-Cloth) using circular motions, allow to dry (to a white powder), then buff off with kitchen roll. The Inox Cream forms a waterproof layer on your sink, which helps the water drain off easier.
The 1810 Company are extremely stringent in the quality and standards required from the steel suppliers. The material used is high quality stainless steel, which is metallurgically incapable of rusting or corroding in normal household conditions.
It can, however, harbour ferrous particles from the water supply and these often occur with newer installations when the pipework is disturbed, or from ‘wire’ scouring pads or utensils. These filings get deposited and cling to the sink surface and unless removed will rust.
In this instance we would recommend that the sink is cleaned thoroughly using a product called ‘Bar Keepers Friend’. This should be sprinkled onto the sink and scrubbed into a paste with a stiff nylon nailbrush (NB simply using a nylon washing up brush is not sufficient as the product needs to be worked into the ‘valleys’ of the texture of the sink), which should be left on the sink for at least thirty minutes before thoroughly rinsing off.
We would point out that unless the particles are completely removed they will return. It is therefore very important that after cleaning the sink, it is dried thoroughly. This process needs to continue at least daily for a period of 7 to 10 days until the problem disappears. The problem is sometimes particularly obstinate to remove and it may take several attempts to restore the sink to its pristine condition. We would also recommend that a product such as ‘ShinySinks’ is used following each application of ‘Bar Keepers Friend’. For information, ‘Bar Keepers Friend’ is available at Sainsburys, John Lewis, Lakeland, Waitrose, larger branches of Tesco and general hardware stores.
The 1810 Company recommend The E-Cloth™ for use on our stainless steel sinks. The E-Cloth™ contains no chemicals, but millions of fibres which literally wipe away all dirt, including grease, using just water. The E-Cloth™ is available from John Lewis stores, House of Fraser, Selfridges, Comet and Currys.
The 1810 Company sinks are guaranteed for 75 years against manufacturing defect. The 1810 Company taps are guaranteed against defective materials and workmanship for 2 years in relation to coatings and finishes, and 2 years in relation to moving parts. The 1810 Company will replace (and where appropriate repair) defective sinks. In relation to taps, The 1810 Company will, where appropriate, provide replacement parts for your taps or replace your taps.
Any associated or ancillary costs to be incurred by you as a result of replacement of The 1810 Company sinks and taps under this guarantee shall in all cases be previously approved by The 1810 Company UK Limited. This guarantee is in addition to and does not affect your statutory rights.
‘Bar Keepers Friend’ Professional Formula Powder Cleaner.
INGREDIENTS: Blend of mineral Surfactant, Oxalic Acid, Inert Mineral Filler, Citric Acid Monohydrate, Thickening Agent, Fragrance.
Product Name: ‘ShinySinks’ Cream Cleaner (Professional).
INGREDIENTS: Water based blend of Mineral Surfactant, Citric Acid Monohydrate, Inert Filler, Thickening Agent, Fragrance and Preservatives.
INGREDIENTS: Water based emulsion (water content76%), contains citric acid (4%) In case of eye contact rinse thoroughly with water. Avoid prolonged contact with skin, wash off with soap and water.
Your new 1810 company Ceramic Sink is a high quality product, and has an impervious surface that is resistant to most household cleaning products and chemicals. Our products are carefully tested to be sure they perform to the highest standards. Please use a damp clean cloth for general cleaning.
Should you need to remove grease, soap and watermarks, a proprietary bathroom cleaner should be used. Please be sure that the products are non-abrasive, as they will dull the gloss surface of the product if used. Using a diluted bleach solution twice weekly applied with a sponge or soft cloth, then rinsed thoroughly with
lots of water, will maintain the surface shine and keep your sink hygienically clean.
(NB: Care should always be taken when using bleach, please read manufacturers instructions for use.) Tougher lime scale deposits can usually be removed using household vinegar or similar vinegar solutions.
Care should be taken when using substances containing fluoride. Always ensure that any deposits are removed immediately before they can cause damage to the sinks surface. Any stubborn marks on the surface can be removed by liquid or cream bathroom cleaner, but marks such as those caused by iron or aluminium saucepans or similar objects can be removed using specialist cleaning products such as ‘Astonish Oven and Cookware Cleaner’ which is available from most supermarkets or online at
Your new sink has a glazed ceramic surface, which although very strong, can be damaged by sharp metallic objects such as cutlery. Special care must be taken not to drop metal objects onto the surface of your sink.
Care needs to be taken not to damage the tap finish – cleaning should be gentle with a rinsed soft mild soapy cloth only. If limescale is a problem around the nozzle then gentle use of a small brush with some lemon juice will help alleviate the problem taking care to rinse away any remaining lemon juice from the tap.
The 1810 Company sinks are guaranteed for 75 years against manufacturing defect. The 1810 Company taps are guaranteed against defective materials and workmanship for 2 years in relation to coatings and finishes, and 2 years in relation to moving parts. The 1810 Company will replace (and where appropriate repair) defective sinks. In relation to taps, The 1810 Company will, where appropriate, provide replacement parts for your taps or replace your taps. Any associated or ancillary costs to be incurred by you as a result of replacement of The 1810 Company sinks and taps under this guarantee shall in all cases be previously approved by The 1810 Company UK Limited. This guarantee is in addition to and does not affect your statutory rights.